|
 |
Booth Information
ADA Requirements
Each exhibitor shall be responsible for compliance with the Americans with Disabilities Act within its booth and assigned exhibit space. Booth Design & Use of Exhibit Space In Standard booth units, all display material is restricted to a maximum height of 44" except for the back wall of the display, which is limited to 8' in height. The booth height may be maintained up to 50% of the distance from the back wall toward the front of the space. No obstructions in the front half of the booth above the height of 44" will be permitted. Models or schematic drawings of cubic content exhibits should be submitted in advance to Exhibit Management for approval. No exhibit may span an aisle by roofing or floor covering. In Island booth units, bound on four sides by aisles, the full cubic content of the space may be used; however, all display material is restricted to 16' in height. Sufficient see-through areas must be provided so as not to block the view of the adjacent exhibits. Models or schematic drawings of cubic content exhibits should be submitted in advance to Exhibit Management for approval Nothing shall be posted, tacked, nailed, or otherwise attached to the walls, floors or other parts of the exhibit facility or furniture contained in the facility. Exposed unfinished sides of exhibit backgrounds must be draped to present an attractive appearance. If such draping is not ordered, the decorator, with the approval of Exhibit Management, will install draping and charge the exhibitor. Demonstration Areas Booth Schematic Diagrams |
